DILEMMA DOCS
Output System · 1 PC

RP2040 Setup

Use an RP2040 board with DilemmaAim PC when gameplay, capture and detection all run on one Windows computer.

1 PC only: Install DilemmaAimPCSetup.exe. The standard DilemmaAim installer is intended for other supported output and capture paths. RP2040 is not the MAKCU firmware mode.

What you need

Connection and output

Connect RP2040 to your PC

Connect the board's USB-C data port to the same Windows PC that runs the game and DilemmaAim PC. For physical controller input, connect the supported controller to the RP2040 board's USB-A host port with a data-capable cable.

Connect keyboard and mouse (native KBM mode)

For native KBM output, connect the keyboard to the gaming PC. Connect a supported mouse to the RP2040 USB-A host port, or use the PC mouse input path if selected in DilemmaAim PC. Choose native KBM output rather than a controller translation mode.

Configure Devices

Open DilemmaAim PC → Devices and choose RP2040 output and the matching controller or native mouse/input option. Native mouse output and controller output are distinct modes; do not translate native mouse movements into virtual controller-stick input.

Select a game capture source

Choose the game window in Capture. You do not need an HDMI capture card or a separate streaming PC for this setup.

Flash RP2040 firmware

The firmware is distributed through DilemmaAim PC, not as a public website download. Flashing requires an active DilemmaAim account session on an authorized device.

Enter bootloader mode

Connect the RP2040 in BOOTSEL mode as directed by the app, so Windows shows the RPI-RP2 drive. On many RP2040 boards, hold BOOTSEL while connecting USB.

Flash from Devices

In DilemmaAim PC → Devices, select Flash Firmware. The app downloads the current RP2040 UF2 through the authenticated API and copies it to the RPI-RP2 drive.

Reconnect

After the board restarts, reconnect normally, select its COM port if needed, and verify the input and output mode.

Firmware compatibility: RP2040 and RP2350 UF2 files are not interchangeable. Never flash RP2040 firmware to an RP2350 board. The app uses the current firmware download directly; no firmware version checks or update prompts are required.

Performance notes

The game and object detection share system resources on a 1 PC setup. If DET FPS is low, cap in-game FPS, lower in-game graphics settings and check the troubleshooting guide.